Wdappmgr is root root # /etc/init.d/atop statusĪtop is root root # /etc/init. Wdtms is root root # /etc/init.d/wdappmgrd status # IN STATUS RUNNING root # /etc/init.d/wdtmsd status Wdnotifier is not root root # /etc/init.d/onbrdnetloccommd status Wdmcserver is not root # /etc/init.d/wdmcserverd info What I have observed is my Plex Media server, running on Windows Server 2012 R2 in the Plex Media Service service container and it uses about 900MB at rest (i have some management agents running) and about 200-300 MB of additional RAM for a 720p transcode and 350-500 MB for a 1080p transcode. Wdphotodbmerger is not root # /etc/init.d/wdmcserverd status To check the status of some root # /etc/init.d/wdphotodbmergerd status Better yet, with the offline mode you can listen to songs stored in the device’s local memory for when no network connection is available. I’m surprised it’s taking this much effort for MP3s when it used to be able to stream a movie with video and audio… I’m sure it’s more than capable, but just getting over this last hurdle will make it more than a paperweight again. Is there a good way to go about determining what is causing the hangup on my server, either in Plex on with the drive itself? Any suggestions on how to revive it so it can be used functionally to at least stream music? On the Plex Dashboard, I have noticed that the server’s RAM is being used at 60%-80%, while Plex (the only app I have installed on the server) is using a minimal amount of the CPU. I do, and it allows me to use PlexAmp, but the problem is that. If I try to access the WD Dashboard, it can sometimes take 3-4 tries before I get in to the server without it timing out. When I run plex with my other 10 containers, cpu usage is at 5-7 and ram usage is at 1. However, even though it’s been a few weeks since I did this, the server (both in the WD Dashboard and the Plex app) responds very slowly and unreliably. I loaded about 60GB of my Google Play Music library on to the server, leaving about 3.9TB free on the drives, and let them index and sync. I decided to delete all of the movies from my WD server, and repurpose it for a music and documents backup server (with the hope that Plexamp would be my replacement once Google Play Music shuts down). In that time, I also bought a Synology server onto which I offloaded all of my movies. This had been an ongoing issue that I chalked up to the two 4TB drives being almost 95% full from movies I had synced through Plex. I posted here a few months ago that I was having difficulty accessing my dashboard on my My Cloud Mirror (Gen 2).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |